Show Network Interface Card NIC Hardware Properties including MAC Address Serial Number using lshw Command.

   Show network interface card hardware properties on Linux fedora using lshw command.  The step by step command example below demonstrate how to use Linux lshw command to show network interface card hardware properties including the network card mac address / network card serial number, network card vendor and product type (network card maker) without open your computer casing and poke on the network card hardware him self.

Network Card

Network Card Hardware Properties

[root@fedora10 ~]# lshw -class network

  *-network

       description: Ethernet interface

       product: 82557/8/9/0/1 Ethernet Pro 100

       vendor: Intel Corporation

       physical id: 4

       bus info: pci@0000:00:04.0

       logical name: eth0

       version: 08

       serial: 00:08:02:e0:af:0c

       size: 100MB/s

       capacity: 100MB/s

       width: 32 bits

       clock: 33MHz

       capabilities: pm bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation

       configuration: autonegotiation=on broadcast=yes driver=e100 driverversion=3.5.23-k4-NAPI duplex=full firmware=N/A ip=172.16.160.119 latency=64 link=yes maxlatency=56 mingnt=8 module=e100 multicast=yes port=MII speed=100MB/s

  *-network DISABLED

       description: Ethernet interface

       physical id: 1

       logical name: pan0

       serial: 96:03:b6:3d:ac:89

       capabilities: ethernet physical

       configuration: broadcast=yes driver=bridge driverversion=2.3 firmware=N/A link=yes multicast=yes

[root@fedora10 ~]#

Keywords:  show network interface card, show nic properties, show network properties, show network hardware information, show network hardware properties, show network mac address, show network serial number